Activity Stream

I'd be worried if someone machined the rotors and re-installed the old pads. There are a very few occasions where you might chance that and none of...

I had an indi have a look, confirms the pads have meant on them. He didnt take the wheels right off, but hoisted it up and crawled under. I can...

OK, so there are 2 parts to the kit, the SW controls with wireless receiver and the Airpro module. Dumb question I assume the SWC receiver and AirPro...

What sort of damage would I be looking at for an installed upgraded exhaust on an RS5?

I'd say it was 10% in volume increase on idle. Once you accelerate, that increase would be at lease 20%, over closed valves. It's still loud enough...

The controls themselves have a CR2032 battery in each one. Its just a cheap eBay set so not sure if you could find info on it. I've tried...

The PFL RS3 is a great car, Wife has had one since new, done around 35ks now. Funnily enough I was just checking Carsales the other day to see what...

Mine is a late 2015 Nardo Grey un-molestered! 34,000km. I wonder how much I'd get for it. Sorry photo upload not working...

Starting with the simple things, the ANT wire is if you have a power antenna, you don't so you don't need it. How are the steering wheel controls...

You were right about supply - not much about! So I've pulled the trigger on an Daytona Grey with blacked out badges via PrivateFleet. Just about to...

I recently installed an ASR valve controller - I'd say it's 5%-10% louder, and an octave lower - a really nice grumble. Not bad for $700,...

Hi All, Apologies if these have been posted previously. Videos from some guys in Sydney, Might Car Mods, going through the process of tuning their...

Unfortunately I can offer some first hand experience with this, had a scared cylinder from what was most likely a melted spark-plug. Looked at...

Agreed. One tough looking unit Sent from my Pixel 5 using Tapatalk

This is a strange one then. If the pads were not replaced then the pads would be still metal-to-metal and the grinding noise should still be there,...

Back to basics. Does the grinding noise only appear when the brakes are applied? If so then it should be a pad / rotor issue. You say the rotors were...

The harmonic noise is still there. Granted it has only been a few days and seems to be getting a little bit better. More concerning is the...

lol i did for a long time too lol

Thanks Alister, sure is

Sold kids!!

Not common at all. Especially in Aus. I believe LA Sleeves and maybe Darton sleeves have one that fit. Sent from my iPhone using Tapatalk

Yeah already done that

Ask the guys at faststuff what they can do for you (or underground tuners) Sent from my SM-G985F using Tapatalk

Can you machine and sleeve these engines? Sent from my SM-G985F using Tapatalk