PDA

View Full Version : Fitting a new Chin Spoiler



jackal
February 14th, 2010, 10:54 AM
http://i69.photobucket.com/albums/i66/TToshiba/FAQ/Chin01.jpg
Use of ramps isn't absolutely necessary but is highly recommended.

http://i69.photobucket.com/albums/i66/TToshiba/FAQ/Chin02.jpg
Replacement chin spoiler in carbon fibre composite.

http://i69.photobucket.com/albums/i66/TToshiba/FAQ/Chin03.jpg
On underside of spoiler punch centre pin in OEM fasteners partially through to facilitate removal. Remove fasteners.

http://i69.photobucket.com/albums/i66/TToshiba/FAQ/chin04.jpg
Set aside for re-use

http://i69.photobucket.com/albums/i66/TToshiba/FAQ/chin05.jpg
OEM spoiler removed.

http://i69.photobucket.com/albums/i66/TToshiba/FAQ/chin06.jpg
Locating Fingers on bumper assembly.

http://i69.photobucket.com/albums/i66/TToshiba/FAQ/chin07.jpg
Push spoiler on to locating fingers on bumper assembly.

http://i69.photobucket.com/albums/i66/TToshiba/FAQ/chin08.jpg
Start at one side and work to the other.

http://i69.photobucket.com/albums/i66/TToshiba/FAQ/chin09.jpg

http://i69.photobucket.com/albums/i66/TToshiba/FAQ/chin10.jpg
Push pin in fastener to other extreme to enable fasteners to be re-used and install into underside of spoiler.

http://i69.photobucket.com/albums/i66/TToshiba/FAQ/chin11.jpg

http://i69.photobucket.com/albums/i66/TToshiba/FAQ/chin11.jpg
Resulting in this.