PDA

View Full Version : Anyone know of a mag wheel repair shop in brisbane



angelshox
February 14th, 2004, 07:08 PM
:beat: does anyone from brisbane know of a mag wheel repair shop? my girlfriend has already scratched my left front s3 mag

February 14th, 2004, 07:24 PM
Alloy wheels can be repaired by a panel shop, they would do just as good a job, even better by my experience.

Dave R32
February 14th, 2004, 10:07 PM
As Wal points out, if it is only scratched take it to a good panel shop, they will sand, fill and paint as required and it should look perfect.

I had one repaired by Hadwens in Bowen Hills after a tyre fitted scratched it.

Hope this helps.

Lams
February 15th, 2004, 12:45 AM
what's the approximate cost? I want to get that ugly wheel fixed :oops:

5VTurbo
February 16th, 2004, 12:05 AM
between $70-$100., but much more if they are bent or cracked.

Aussie Audi Guy
February 16th, 2004, 09:58 AM
DEPULU wheel repairs on the Gold Coast are probably the best in the state. They do all the work for Audi, Porsche etc etc. So if its more than just paint, give them a try. I have had them repair flat spots & missing chunks out of wheels. Also worth a try is Race Engineering at Sumner Park, they are repairing my American racing rims again

XXX-1.8T
February 16th, 2004, 10:05 AM
Poor rim Guy that road bent it good i was like :shock:

Aussie Audi Guy
February 16th, 2004, 10:32 AM
:swear:
http://www.ozaudi.com/dyno/deadwheel.jpg

Lams
February 16th, 2004, 12:48 PM
how did you do that Guy?

I think it's just paint with very little chunks off my wheel, but it's not bad enough for me to spend $70 on it so I'll wait for more chunks :roll:

Aussie Audi Guy
February 16th, 2004, 02:37 PM
Brisbane City Council & one large pothole on the southside of the story bridge, middle lane southbound, watch out. Rear was dented as well, but not as bad.... :beat: