Tab Content
  • jsol's Avatar
    August 16th, 2018, 10:48 AM
    Check the wiring to the speed sensor and if that is ok then test/replace the speed sensor. That would be my approach. You can check the measuring...
    2 replies | 93 view(s)
  • jsol's Avatar
    August 15th, 2018, 11:43 PM
    Oh, and if your looking at 01E trans from a B6 it will have to be a relatively early model before they changed to the 02X. If you want to keep the...
    8 replies | 171 view(s)
  • jsol's Avatar
    August 15th, 2018, 11:28 PM
    jsol replied to a thread B5 S4 for sale in ignore Cars
    Yes mate.
    9 replies | 1178 view(s)
  • jsol's Avatar
    August 15th, 2018, 11:26 PM
    Main difference between 01E transmissions is those that have a wide or narrow first gear and/or a flexible main shaft. I have found a lot of the late...
    8 replies | 171 view(s)
  • jsol's Avatar
    August 15th, 2018, 11:06 PM
    0A3 in B6 S4 not 02X. O2X is a low tq gearbox, 0A3 med tq. Both have problems with dog rings coming off the gears in high tq applications. They shift...
    8 replies | 171 view(s)
  • jsol's Avatar
    August 10th, 2018, 08:02 AM
    jsol replied to a thread B5 S4 for sale in ignore Cars
    Just had the turbos measured for play (they were in spec), I was going to replace them but they are still good. New gaskets etc to fix the leaks....
    9 replies | 1178 view(s)
  • jsol's Avatar
    August 8th, 2018, 05:13 PM
    Set of lightly used (only about 2000kms) Continental struts and bags. $300 plus postage. Can deliver anywhere between Port Maquarie to Brisbane next...
    0 replies | 82 view(s)
  • jsol's Avatar
    August 1st, 2018, 08:14 AM
    jsol replied to a thread B5 S4 engine out in ignoreA4, S4, RS4
    Yeah thanks guys, good to just get in and drive now. Now I can finish rebuilding my honda pump motor then get the V8 swap back into the shed.
    17 replies | 933 view(s)
  • jsol's Avatar
    July 31st, 2018, 07:43 PM
    jsol replied to a thread A4 B7 Seats into A4 B5? in ignoreA4, S4, RS4
    No, the brackets are different. You can do it if you cut out your floor brackets and weld in a set from a B7. Also wiring won't PnP though custom...
    4 replies | 147 view(s)
  • jsol's Avatar
    July 31st, 2018, 07:04 PM
    jsol replied to a thread B5 S4 for sale in ignore Cars
    Back up for sale.
    9 replies | 1178 view(s)
  • jsol's Avatar
    July 31st, 2018, 06:51 PM
    jsol replied to a thread B5 S4 engine out in ignoreA4, S4, RS4
    It's hard to see the nice clean engine under all the clutter. No leaks after a shakedown so very happy.
    17 replies | 933 view(s)
  • jsol's Avatar
    July 31st, 2018, 06:48 PM
    jsol replied to a thread B5 S4 engine out in ignoreA4, S4, RS4
    After plenty of swearing I got the slave out and pre loaded it and tied a piece of ribbon (the kind you use for presents) around it. It was easier to...
    17 replies | 933 view(s)
  • jsol's Avatar
    July 31st, 2018, 06:44 PM
    jsol replied to a thread B5 S4 engine out in ignoreA4, S4, RS4
    I had it all together yesterday but when I went to push the clutch pedal it wouldn't budge so I knew the slave hadn't seated in the clutch fork!...
    17 replies | 933 view(s)
  • jsol's Avatar
    July 26th, 2018, 07:25 PM
    jsol replied to a thread B5 S4 engine out in ignoreA4, S4, RS4
    Get in there!
    17 replies | 933 view(s)
  • jsol's Avatar
    July 26th, 2018, 07:21 PM
    jsol replied to a thread B5 S4 engine out in ignoreA4, S4, RS4
    Same with drivers side. I had a mate come and measure the axial play on the turbos (he's a diesel truck mechanic) and he said they were fine. There...
    17 replies | 933 view(s)
  • jsol's Avatar
    July 26th, 2018, 07:03 PM
    jsol replied to a thread B5 S4 engine out in ignoreA4, S4, RS4
    Passenger side back together with new gaskets.
    17 replies | 933 view(s)
  • jsol's Avatar
    July 26th, 2018, 04:41 PM
    Maybe a silly question but are they oem lights (not aftermarket)?
    2 replies | 146 view(s)
  • jsol's Avatar
    July 22nd, 2018, 09:30 PM
    Very nice mate.
    26 replies | 1195 view(s)
  • jsol's Avatar
    July 21st, 2018, 05:51 PM
    jsol replied to a thread 4.2 V8 turbo in ignoreA4, S4, RS4
    If someone would hurry up and buy one of my S4's I could splurge some coin on this build. My wife say's a car must go before more expenditure. A lot...
    150 replies | 10499 view(s)
  • jsol's Avatar
    July 20th, 2018, 08:10 PM
    jsol replied to a thread 4.2 V8 turbo in ignoreA4, S4, RS4
    Yeah, it's a beast. I was following his build thread on AZ then halfway through he deleted all his posts.
    150 replies | 10499 view(s)
No More Results
About jsol

Basic Information

Date of Birth
January 25, 1975 (43)

Statistics


Total Posts
Total Posts
567
Posts Per Day
0.22
Albums
Total Albums
1
Total Photos
40
Total Thanks
Total Thanks
0
General Information
Last Activity
Today 08:29 PM
Join Date
July 21st, 2011
Referrals
0