Search:

Type: Posts; User: rockersteady; Keyword(s):

Page 1 of 12 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    122
    Views
    21,351

    Well That was 6th Jan 2018, its been installed,...

    Well That was 6th Jan 2018, its been installed, I had an entry in Aus Time Attack for today (July 24th 2021) but that's been cancelled of course...
    31887 31888 31889 31890 31891 31892
    ...
  2. Replies
    9
    Views
    1,060

    " My problem is that the fuel gauge is...

    " My problem is that the fuel gauge is malfunctioning – when the tank is full it reads ‘empty’, and stays showing empty right up to when the tank is less than full, when the gauge jumps straight...
  3. Replies
    9
    Views
    1,060

    Q. did you test the level sender against the fuel...

    Q. did you test the level sender against the fuel gauge (ie hooked up normally) while it was out of the tank?

    Ground for that one should be the earth lug on drivers side of under dash just above...
  4. Replies
    383
    Views
    43,919

    Hi Mike!

    Hi Mike!
  5. Replies
    10
    Views
    1,578

    Sliding cams in the Overhead cam'd Audi, zinc is...

    Sliding cams in the Overhead cam'd Audi, zinc is the preferred anti gall agent with such high loads, where an oil film cant be carried on the upper end high spots (don't forget- under the microscope...
  6. Replies
    10
    Views
    1,578

    Totally worth doing for a new engine, during and...

    Totally worth doing for a new engine, during and post initial break in. Modern or rebuilt older engine. Fresh design in engine has potential unknowns- Especially to the end user- Designs are messed...
  7. Replies
    23
    Views
    3,269

    So those manifolds are for stock turbos, and the...

    So those manifolds are for stock turbos, and the Clutch disc Standard looking friction material but for a single mass? I saw the scored bore but I figured this was unknown till you pulled it apart,...
  8. Replies
    23
    Views
    3,269

    Hi Tony, Whats the goal here? I see a few pics...

    Hi Tony,
    Whats the goal here? I see a few pics of parts, but you are being a bit cryptic (or I cant read it as my mind works in logic only and data must be input correctly or I cant Kompute) or in...
  9. Replies
    34
    Views
    8,281

    Way on the back Burner, Possible options are...

    Way on the back Burner,
    Possible options are leaning toward it will getting a built 1.8t in it though, My B4 80 quattro's getting a 2.5 tall deck stroker first, Although the Cars there to be built...
  10. Replies
    118
    Views
    17,455

    Sticky: Audi failed it, My 2000 B5 A4 is currently...

    Audi failed it, My 2000 B5 A4 is currently registered NSW , I never got a letter from Audi for it, Its not on the affected VIN's list- the airbag was removed and fitted to an A4 that was on the VIN...
  11. Replies
    118
    Views
    17,455

    Sticky: I can add this, My 2000 A4B5 is not on the Vin ...

    I can add this, My 2000 A4B5 is not on the Vin recall list (I have 2 other b5s both '99 that are) I removed the bag from my 2000 and fitted it to a buddies A4 that was affected, IT FAILED inspection.
  12. Replies
    8
    Views
    1,167

    The 240mm (stage 3) clutch in this car drives...

    The 240mm (stage 3) clutch in this car drives smooth!! feels like factory- but the owner stalled it several times getting used to where it bites on the pedal (he was used to his mushy stock...
  13. Replies
    8
    Views
    1,167

    factory rod safe Max ouput tune

    Metric
    31589 193awkw

    Ole Skool

    31590 259awhp

    222FT/LBS at all wheels = 297 ft/lbs at crank. Pretty much spot on 300ft/lbs rod safe max torque.

    job done.!
  14. Replies
    8
    Views
    1,167

    Tuning 31585 Airbox made up (Keep it all...

    Tuning
    31585
    Airbox made up (Keep it all legal... cant have a open pod filter.....!)


    Chuck a quick tune at it- tuned the factory ecu, running 500cc, VR6 maf housing and 98ron, 20psi will...
  15. Replies
    8
    Views
    1,167

    Exhaust

    Exhaust
    I had an 2.5' Exhaust laying around from a very well known Audi Performance Race shop in Good old USA that I chucked on minus turbo dump/cat
    31586 31587 31588

    100cell...
  16. Replies
    8
    Views
    1,167

    relocate Starter supply cable and fabricate the turbo intake pipe with attachments

    Starter power supply cable well and truely in a bad spot- direcly in line of fire of the turbo dump
    31579

    A little massaging of the cable and tucked it under the heat shield following the frame...
  17. Replies
    8
    Views
    1,167

    Turbo Mock up and clocking

    The supplied Mamba GT2860 turbo and side mount manifold is a generic kit, it needs a lot of twiddling to get everything lined up the right way-
    turbo outlet headed down towards original hard charge...
  18. Replies
    8
    Views
    1,167

    Ringer racing stage 3 with 240mm flywheel going...

    Ringer racing stage 3 with 240mm flywheel going in, This clutch is full face which means long lasting and smooth,
    its also cerametalic one side and organic the other- what this means is HOLDING...
  19. Replies
    8
    Views
    1,167

    Audi A4 B5 Quattro 1.8t GT2860 build

    Hi All,
    Thought Id show case a Audi A4 1.8T Quattro just got finished building and tuning,
    Beautiful red Duco Pre facelift with only 195k on the clock.

    Build included (Clean this up for...
  20. Replies
    122
    Views
    21,351

    Aus Time attack was a lot of fun... Practice day...

    Aus Time attack was a lot of fun... Practice day prior was even better.
    I thought I had a lot of time to prepare for the event , But builds of other cars took priority and on top of that the cage...
  21. Replies
    122
    Views
    21,351

    like this? a six point cage with intrusion bars...

    like this? a six point cage with intrusion bars (Drivers side is currently off while I fitted the seat) needs six point harness. and some fresh Nankang AR1 (well not brand new as I just tested...
  22. long live the A4

    long live the A4
  23. Replies
    122
    Views
    21,351

    31550 31549

    31550

    31549
  24. Replies
    5
    Views
    859

    You got that right!! Tracking went dead as soon...

    You got that right!! Tracking went dead as soon as it hit the senders Post office, 2 weeks late it arrived! Must have been your encouraging words!


    Thanks the offer! all sorted now as the...
  25. Replies
    5
    Views
    859

    Wanted- A4 1.8T performance clutch

    Hi All,
    Ive had a clutch go missing in the post and need to replace it, anyone got a new or used performance clutch set up laying around not yet fitted?
    from any 1.8t A4 (B5 or B6/B7)
    Im in...
Results 1 to 25 of 300
Page 1 of 12 1 2 3 4