Q5 tfsi 2L EPC light.

[Mythos Q5]

So I scanned it with OBDELEVEN and it’s saying turbo positioning sensor. It is only intermittent coming on under light excaleration.
If I drive it hard no light comes up.
Question? If I change out the actuator does it need to be coded with VCDS or alike. Cheers Simon


Sent from my iPhone using Tapatalk

[jnrdavo]

normally changing a part does not require new coding in vcds, just clearing the error codes.

Some interesting reading here, where the potential same error was actually a leak..

Fault code P2563 Turbocharger Boost Control Position Sensor Circuit: Implausible Signal | Audi-Sport.net

[Mythos Q5]

normally changing a part does not require new coding in vcds, just clearing the error codes.

Some interesting reading here, where the potential same error was actually a leak..

Fault code P2563 Turbocharger Boost Control Position Sensor Circuit: Implausible Signal | Audi-Sport.net

Ok cheers.
Thinking I just change the actuator then. Mine Is petrol and occasionally the electric actuator arm stays out. I could drive for ten minutes and it will happen and other times a hour or two. When I turn the car off it retracts back in no problem.
I’ve cleaned and checked all wire connections and de carbon the turbo veins. Also clean the MAP sensor.


Sent from my iPhone using Tapatalk