Search results

Well That was 6th Jan 2018, its been installed, I had an entry in Aus Time Attack for today (July 24th 2021) but that's been cancelled of course... Plenty of time now to get the limited aero allowed in Clubsprit class figured out- aero is quite a involved undertaking and its...

factory rod safe Max ouput tune Metric 193awkw Ole Skool 259awhp 222FT/LBS at all wheels = 297 ft/lbs at crank. Pretty much spot on 300ft/lbs rod safe max torque. job done.!

Tuning Airbox made up (Keep it all legal... cant have a open pod filter.....!) Chuck a quick tune at it- tuned the factory ecu, running 500cc, VR6 maf housing and 98ron, 20psi will do - not too much boost to keep intake and cylinder temps low enough amp torque with timing :big_wink:

Exhaust Exhaust I had an 2.5' Exhaust laying around from a very well known Audi Performance Race shop in Good old USA that I chucked on minus turbo dump/cat 100cell race cat fitted, a bit further back to help the turbo spool

relocate Starter supply cable and fabricate the turbo intake pipe with attachments Starter power supply cable well and truely in a bad spot- direcly in line of fire of the turbo dump A little massaging of the cable and tucked it under the heat shield following the frame rail sorted that out...

Turbo Mock up and clocking The supplied Mamba GT2860 turbo and side mount manifold is a generic kit, it needs a lot of twiddling to get everything lined up the right way- turbo outlet headed down towards original hard charge piping, wastegate actuator pointing towards wastegate and clearing...

Ringer racing stage 3 with 240mm flywheel going in, This clutch is full face which means long lasting and smooth, its also cerametalic one side and organic the other- what this means is HOLDING POWER at 528 ftlbs rating the rods will bend like twizzle sticks before this clutch lets go!

Hi All, Thought Id show case a Audi A4 1.8T Quattro just got finished building and tuning, Beautiful red Duco Pre facelift with only 195k on the clock. Build included (Clean this up for starters- YUK) Full major service- Timing belt/water pump/ thermostat. All aux belts and Cam chain...

like this? a six point cage with intrusion bars (Drivers side is currently off while I fitted the seat) needs six point harness. and some fresh Nankang AR1 (well not brand new as I just tested the new package at Wakefield track day yesterday) And something to keep Tony happy too.. (I...

Hi All, Ive had a clutch go missing in the post and need to replace it, anyone got a new or used performance clutch set up laying around not yet fitted? from any 1.8t A4 (B5 or B6/B7) Im in Sydney but happy to pay shipping to me (Happy as long as it arrives!!) cheers, Ed ZERO 4 505 7527 THREE

Testing/Tuning/Practise was undertaken last Wednesday at a top secret location Hope to do some more testing/ Practice if I can- Dec 6th at Wakefield

a little splash of go faster stickers, and finally fit some different wheels

Huntley Hill Climb- last multi Club hill climb for this year at Huntley Hill. QMS has prepared the regular 2 A4 B5's quattro's and finishing off a rod install on a 1.8t B6 Avant running a modified 2860 on e85 to run as well! Come over with your Audi and enter...

B5 audi Quattro making a stand at the Hill. 2 audi A4 B5 quattroes entered in this really fun spectator track event on Sunday 18th August, Jsol with his V8 swapped b5 and my B5. Come and say hello- a real fun day filled with cars and owners slinging them at the mountain Ed

Gates open at 7am, first session starts? Any rate I try to be there as early as I can and run till the last session. practice practice practice! a bit of a boost leak on the charge pipe leaving the turbo. 034 rear anti sway bar installed and the accompanying sub frame re-enforcing brackets...

Bit of a rush getting it all together- just a few hours to prep and re-tune it , a loan of a tyre inflator to adjust air pressures at the track. Got really hot later in the day, (39 degrees C) but she coped well but oil temps rose to 120c and had to limit to 4 laps at a time with a cool down...

Treated myself, and bought a new car. hang on , hang on- build plate says 1990? Dumped the old fuel- left the oil in it- looks fresh enough, starts but not injecting Fuel post start up. it will run on occasionally for a few more sec. - some trouble shooting for next week (i did lift the...

begging for it, An engine-less 90Q 2 An engineless 1990 90Q Has arrived- its much better shape than i expected, paint is intact (save the roof and bootlid, which needs new clear) And an engine - it has everything but an longblock (no intake mani- but wont need it as will go turbo i5 20v or...